Icemaker Installation; Prepare For Installation - GE GTH21 Série Manuel D'utilisation Et D'installation

ICEMAKER INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
refrigerator. To eliminate the danger
you must unplug the refrigerator from
its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" Nutdriver or adjustable wrench

PREPARE FOR INSTALLATION

1
rear freezer wall.
plug
2 MOVE FEELER ARM TO THE STOP
POSITION
Move the feeler arm to the STOP (up) position. Leave the
feeler arm in the STOP position until the refrigerator is
connected to the water supply to prevent premature
operation.
(Appearance may vary)
Installation Instructions
Unplug the
Pliers
Feeler
Arm
3 INSTALL THE ICEMAKER FILL CUP
Install the
icemaker as shown.
4 PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the
cord plug into the socket, making sure that the prongs
and holes are matched. Press the plug firmly into the
socket. Lock the plug in place by clipping the restraints
onto each side of the plug. Make sure the restraints click
into place. Make sure the power cord is still in the hook on
the back of the icemaker.
MOUNT THE ICEMAKER
5
fill tube extension (8) fits
in the fill cup opening (C).
Hang the icemaker on the
two mounting screws (A).
fill tube extension (8) is still in the fill cup opening.
(Check the rear of the refrigerator to make sure the
fill tube has not been pushed out of the back of the
refrigerator.)
uppermost position of the mounting slots.
THEN TIGHTEN THE ICEMAKER MOUNTING SCREWS
SECURELY.
13
(side-mounted) (15) into the
15
the
8
A
C