Cleaning; Troubleshooting - Clatronic MWG 779 H Mode D'emploi

Example: 7:30 minutes cooking time at 100% power;
start time 14:20 o'clock
Step Button
1 MICROWAVE
START/+30SEC./
2
CONFIRM
3
4 CLOCK/PRE-SET
5
6
CLOCK/PRE-SET
7
START/+30SEC./
8
CONFIRM
Note:
During this programmed setting the functions of the controls
►
are blocked (except: CLOCK/PRE-SET and STOP/CLEAR).
If you wish to display the start time again, press the CLOCK/
►
PRE-SET button.
When the pre-set time has been reached, the microwave will
►
start operation. Two signal tones will indicate the start.
Warning: Risk of fire!
Always supervise the device during operation.
►
When using the time-delay function, set the time in such a
►
way that the device will be operating under proper supervi-
sion.
Do not operate the microwave empty.
►
If you take the food earlier from the device, you will have to
►
terminate the function by pressing the STOP/CLEAR button.
After the time has elapsed the device will turn off and 5 signal tones
will sound. Take the food from the device.
Locking (Child-proof lock)
Press and hold the STOP/CLEAR button for more than 3 seconds
to lock the device. The display will show the locked setting. The
functions of the controls are blocked. Press and hold the STOP/
CLEAR button again for more than 3 seconds to unlock.
Display function
• During microwave, grilling, combination or convection (without
preheating) mode, the mode or temperature setting is displayed
by pressing the buttons MICROWAVE, DOUBLE GRILL/COMBI.
or CONVECTION for 2 - 3 seconds.
• In disregard to the operation mode, the display will be showing
the current time for 2-3 seconds when pressing the CLOCK/
PRE-SET button.
• During time-delay mode, press the CLOCK/PRE-SET button to
display the start time.
82
Display
P100 (Power setting)
7:30
(Cooking time)
10:45 (Current time)
14:45 (Set hour)
14:45
14:20 (Set minutes)
10:45
(Current time)

Cleaning

Turn the microwave off and disconnect the plug.
Interior
• Keep the interior of the microwave clean. Use a damp cloth to
remove splashing and spilling on the walls of the microwave. If
the device is very dirty, you may also use a mild detergent. Do
not use aggressive detergents.
• Use a damp cloth to wipe the viewing window inside and
outside, and regularly remove splashing and spots caused by
spilled liquids.
Exterior
• Clean the exterior walls of the enclosure with a damp cloth only.
Make sure no water enters the openings in the enclosure and
therefore the inside of the device.
• Use a damp cloth to clean the switches. When cleaning the
function switches, first open the door in order to avoid acciden-
tally switching on the device.
Accessories
• If required, clean the metal plate with dish detergent.
• Regularly clean the guide ring and the inside of the bottom. You
may remove the guide ring and manually clean it. Use a mild
detergent or glass cleaner. Dry thoroughly. Make sure to position
the ring properly afterwards.
Odor
• In order to remove unpleasant odor in the microwave, place
a bowl suitable for microwave use filled with water and lemon
juice in the device and heat for approx. 5 minutes. Then wipe the
oven with a soft cloth.
Oven lights
• Please contact a service center for replacing the oven lights.

Troubleshooting

Malfunctions are often just caused due to minor problems. Before
contacting our customer service, please check the table below:
Problem Possible cause
Radio or TV The electromagnetic
reception is fields of this device
interrupted dur- might interfere with the
ing microwave pictures and sound of
operation. special frequencies.
The device is Defect wall socket.
not supplied with
electricity; the
display is black.
The display There was a power
shows "0:00" failure.
Notes/ solution
This is normal and not
a malfunction. Position
the devices further away
from each other.
- Try another wall
socket.
- Check the main fuse in
your household.
Set the clock again.