Special Functions; Cleaning; Troubleshooting - Clatronic MWG 775 H Mode D'emploi

Special functions

Locking
• Press the STOP/CLEAR/CLOCK button and START/+30SEC./
CONFIRM button simultaneously to lock the device.
NOTE:
• The display will show the locked setting.
• The functions of the controls are blocked.
WARNING:
Turn the microwave off and disconnect the plug.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Do not use a metal scraper to clean the viewing window. The
surface could be scratched and the glass could possibly break.
Interior
• Keep the interior of the microwave clean. Use a damp cloth to
remove splashing and spilling on the walls of the microwave. If the
device is very dirty, you may also use a mild detergent.
• Use a damp cloth to wipe the viewing window inside and outside,
and regularly remove splashing and spots caused by spilled liquids.
Exterior
• Clean the exterior walls of the enclosure with a damp cloth only.
Make sure no water enters the openings in the enclosure and there-
fore the inside of the device.
• Use a damp cloth to clean the switches. When cleaning the function
switches, first open the door in order to avoid accidentally switching
on the device.
Accessories
• Clean the glass tray occasionally with dish detergent or in the dish-
washer.
• Regularly clean the guide ring and the inside of the bottom. You may
remove the guide ring and manually clean it. Use a mild detergent
or glass cleaner. Dry thoroughly. Make sure to position the ring prop-
erly afterwards.
Odor
• In order to remove unpleasant odor in the microwave, place a bowl
suitable for microwave use filled with water and lemon juice in the
device and heat for approx. 5 minutes. Then wipe the oven with a
soft cloth.
Oven lights
• Please contact a service center for replacing the oven lights.
• Press the STOP/CLEAR/CLOCK button and START/+30SEC./
CONFIRM button again simultaneously to unlock.
Display function
• When pressing the MICROWAVE, GRILL, CONVECTION, COMBI.
or DEFROST button for 2-3 seconds during operation, the display
will show the current temperature or function setting.

Cleaning

Malfunctions are often just caused due to minor problems. Before con-
tacting our customer service, please check the table below:
Problem
Radio or TV reception
is interrupted during
microwave operation.
The device is not sup-
plied with electricity;
the display is black.
The display shows
"0:00"
The device does
not start operation.
The display shows a
readout other than the
current time.
All controls are locked. The child-proof lock is
The turn-table causes
a scratching or abrad-
ant noise.
The operation is
terminated without any
obvious reason.

Troubleshooting

Possible cause Notes/solution
The electromagnetic This is normal and not
fields of this device a malfunction. Position
might interfere with the the devices further
pictures and sound of away from each other.
special frequencies.
Defect wall socket. - Try another wall
socket.
- Check the main fuse
in your household.
There was a power Set the clock again.
failure.
The door is not prop- Check if there are ob-
erly closed. jects or food remains
jammed in the door.
The START/+30SEC./ Press the
CONFIRM button START/+30SEC./
was not pressed after CONFIRM button,
selecting the function. or press the STOP/
CLEAR-CLOCK but-
ton to terminate the
process.
Press the STOP/
activated. CLEAR/CLOCK
button and the
START/+30SEC./
CON-FIRM button
simultaneously to
unlock.
There are dirt or for- Remove possible ob-
eign objects in the area jects and food remains
of the turntable shaft. as described under
"Cleaning".
The device is defect. Please contact our
customer service.
71