Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. The lateral cut-outs at the bracket (a) must be placed on
the grid projections (b) in the casing. Press the filter holder
slightly downwards by the bracket.
2. Move the bracket forwards to arrest the filter holder.
It should now no longer be possible to remove the filter holder.
NoTE:
Before making coffee for the first time, allow water to pass
through the device two to three times in order to clean it.
Electrical Connection
NoTE:
Please ensure that the device is switched off. The switch must
be on „0".
Insert the mains plug into a properly installed 230 V, 50 Hz
socket with earthing contact. For information please see the type
plate on the device.
•
Fold open the water tank lid.
•
Fill the rear water container with water. For the desired
number of cups, see the water level indication at the device.
NoTE: You can use the pot to fill the water tank.
CAUTIoN:
Do not overfill the tank! Do not fill it above the 12 mark.
•
Observe correct fit of the filter holder when inserting it (see
"Before Initial Use").
•
Turn over the lower fold of the paper filter (size 1x4) and
place it in the filter funnel. Then fill it with coffee powder.
•
Close the lid of the water tank until it is heard to click into
place.
•
Place the pot on the trade.
CAUTIoN: ANTI-DRIP SySTEM
Please ensure that the lid is on the pot. This activates the
so-called anti-drip system.
•
Your device has an anti-drip system. If the pot is
removed before all of the water has passed through
the filter, this prevents the coffee from dripping on to
the base.
22
05-KA 3346.indd 22
operation
CAUTIoN: ANTI-DRIP SySTEM
•
If there is still water in the tank, place the pot under-
neath as soon as possible. Otherwise the filter might
overflow.
•
Turn the device on.
NoTE:
•
The control lamp in the switch lights up.
•
When the tank is full, the brewing process will take
approx. 10 minutes.
•
When no more coffee is flowing through the filter you can
remove the pot.
•
Turn the device off. The control lamp goes out.
•
If you would like to keep the rest of the coffee warm, the
switch must remain in the „I" position. The hotplate will keep
the coffee warm until you move the switch to „0".
NoTE:
•
The filter holder can be removed from the machine by its
handle. This makes it easier to dispose of the old coffee
filter, for example.
•
Observe correct fit of the filter holder when inserting it
(see "Before Initial Use").
WARNING:
If you would like to make another pot of coffee immediately,
please turn the machine off. Allow it to cool down with the
water tank open in order to prevent hot water splashing out
when the machine is refilled.
Descaling
It is necessary to descale the coffee machine if the preparation
time becomes considerably longer.
•
Only a commercially available decalcifier on a citric acid
base should be used for descaling.
•
Please use the quantities stated on the pack or instruction
leaflet.
•
After descaling, please boil fresh water without coffee in the
machine several times (approx. 3-4 times).
•
This will remove any residues from the descaling process.
•
Do not use this water for consumption.
Cleaning
WARNING:
•
Before cleaning, always remove the mains plug and wait
until the device has cooled down.
•
Do not immerse the device in water. Otherwise this might
result in an electric shock or
CAUTIoN:
•
Do not use a wire brush or any abrasive items.
•
Do not use any acidic or abrasive detergents.
•
The exterior of the device should be cleaned as necessary
with a slightly damp cloth – without any additives.
•
The coffee pot and the filter pad should be cleaned by rins-
ing in warm water. Use a soft brush if necessary.
fire.
06.04.2010 12:09:14 Uhr
M
P
P
F
P
N
T
C
v
t
S
P
i
P
u
T
e
T
t
I
c
Publicité
Table des Matières
