Table des Matières
Publicité
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Max. flow rate @ 80 PSI
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly be-
fore beginning installation. Make sure that you
have all tools and supplies needed to complete
the installation.
• Inspect the product for shipping damage
before installation. Hansgrohe will not
honor claims for shipping damage after
the product is installed.
• This showerpipe is for use with rough set
16181181 (not included).
• Showerpipe 26020001 is for use with shower-
heads rated at 2.2 GPM (8.3 L/min) or higher.
• The installation dimensions stated in these installa-
tion instructions are ideal for people of approxi-
mately 5'11" (1800 mm) in height. The mounting
height can be changed if required. However,
please note that changing the mounting height
of the showerpipe will also change the minimum
ceiling height, and that the other mounting dimen-
sions will change.
• Make sure that the wall where the showerpipe is
to be installed is flat (no projecting joints or tiles),
and that the wall is strong enough to support the
showerpipe. The installation of stringers
at the mounting points is very strongly
suggested.
• The enclosed screws and anchors are suitable
for solid surface walls. If installing in a fiberglass
or acrylic shower module, please contact the
manufacturer of the module regarding suggested
2
15 - 75 PSI
145 PSI
120° - 140° F*
*Please know and follow all applicable local plumbing
176°F*
codes when setting the temperature on the water heater.
2.5 GPM
• Do not install this showerpipe in a steam shower.
• To insure correct function of the thermostatic mix-
• To prevent scald injury, the maximum output tem-
• The shower arm is intended to support the show-
• The showerpipe must not to be used as a
• Keep this booklet and the receipt (or other proof
mounting points, wall reinforcement, and mount-
ing hardware.
ing valve, the hot supply must be on the left and
the cold supply must be on the right. If the hot
and cold supplies are reversed, the mix-
ing valve cannot function correctly.
perature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum out-
put temperature can be no higher than 112° F.
erhead only. Do not hang other objects on the
shower arm.
grab bar. Please install a separate grab
bar if one is required.
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicité
Table des Matières
