Electrical Connections - Tecumseh AJ2 Série Notice D'installation

5.7. Soldering of the oil equalization connector for duo or parallel compressors
10°
5.8. Suspension
All Tecumseh compressors are supplied as standard with an external suspension kit comprising vibration absorbers and braces.
These vibration absorbers are designed to dampen the transmission of the vibrations generated by the compressor through the base
on which the compressor is mounted. In order to ensure this function is provided correctly, the vibration absorbers must never be
restricted. For this purpose, the washer resting on the spacer must allow for a play of 1 to 4 mm with the top of the vibration
absorber.
To avoid deformation of the spacer, apply a tightening torque between 8 and 13 Nm for M8 screws.

5.9. Electrical connections

The electrical connections will be carried out before the refrigerating system is loaded with refrigerant.
To preserve the quality of the Tecumseh compressor, the safety of the installation and to ensure correct operation and function, it is
essential that the following is observed:
- Always wire the compressor when it is disconnected from the main voltage.
- Check the compatibility of the supply voltage for the installation with the supply voltage for the compressor (see serial label).
- Check the compatibility of the electrical diagram for the compressor with the electrical diagram of the installation.
- Dimension the connection cables (power, control) according to the characteristics of the installed compressor (see serial label).
- Protect the electrical power supply line and install a grounding cable.
- Perform the electrical connections in accordance with the regulations in force in the country of installation.
- Use the electrical components supplied with the compressor, even if other references appear to be satisfactory.
Before soldering the oil equalization tube for AJP compressors,
tilt the compressor by at least 10° as shown.
22