Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
With the control located on the front of the appliance (Picture 1 Position A ), it is possible to adjust the heat
emission of the same. This is to be opened according to the calorific need. The best combustion (with
minimum emissions) is reached when, by loading the wood, most part of the air for combustion flows
through the secondary air register.
Never overload the appliance (see the hourly wood load in the table here below). Too much fuel and
too much air for the combustion may cause overheating and then damage the stove.
You should always use the stove with the door closed in order to avoid damages due to overheating
(forge effect).
The inobservance of this rule makes the warranty expire.
Max quantity in ( kg )
Secondary Air (under):
Secondary Air (above):
The STELLA stove is an appliance with intermittent operation.
Besides the adjustment of air for combustion, the intensity of the combustion and consequently the thermal
performance of your appliance is influenced by the stack. A good draught of the stack requires a stricter
adjustment of air for combustion, while a poor draught requires a more precise adjustment of air for
combustion.
To verify the good combustion, check whether the smoke coming out from the stack is transparent.
If it is white, it means that the appliance is not properly adjusted or the wood is too wet; if instead the
smoke is grey or black, it signals that the combustion is not complete (it is necessary a greater quantity of
secondary air.
13. OPERATION DURING TRANSITION PERIODS
During transition periods when the external temperatures are higher, if there is a sudden increase of
temperature it can happen that the combustion gases inside the flue cannot be completely sucked up.
The exhaust gases do not come out completely (intense smell of gas). In this case, shake the grating more
frequently and increase the air for the combustion. Then, load a reduced quantity of fuel in order to permit a
rapid burning (growing up of the flames) and the stabilization of the draught.
Then, check that all openings for the cleaning and the connections to the stack are air-tight.
14. USE OF THE FAN
To increase the efficiency of the stove, start the fan by pressing the switch placed on the back of the
equipment. The ventilation shall start when reaching a temperature pre-set by the manufacturer.
Before proceeding with the connection, check that:
-
the power supply voltage is the same as the one indicated on the data plate;
-
the ground socket outlet is correct.
In those cases in which the socket outlet is not easily accessible, the installer must foresee a switch with
opening distance of contacts equal to or greater than 3 mms.
IMPORTANT: The manufacturer has no liability for damages caused by the lack of observance of
the standards in force and recommends to check that the grounding of the
equipment is correct.
15. MAINTENANCE AND CARE
Let the installation of your stove, the connection to chimney and the ventilation check by your chimney
sweeper. For the cleaning of enamelled surfaces use soap water or not aggressive and not chemically
abrasive detergents.
IMPORTANT: It is possible to use exclusively spare parts clearly authorized and offered by LA
NORDICA. In case of need please apply to your dealer!
32
FUEL
Primary air
Wood (length 30cm, circumference 30 cm )
open 10 mm
open 10 mm
open 04 mm
3
1192000 Rev.03 – EN
STELLA
Publicité
Table des Matières
