Factory Settings; External Control - Kemper KHS HS2 Instructions De Montage Et De Service

Commissioning
Requirements
The commissioning and fault analysis of the
KHS Hygiene Flushing Box 2 are carried out by
a smartphone and the KEMPER HS2 app. The
KEMPER HS2 app is available for free for
Android and iOS smartphones in the respective
App Store (see
communicates via Bluetooth interface with the
KHS Hygiene Flushing Box 2
Commissioning with
KEMPER HS2 app
When installed and connected, the red LED of
the KHS Hygiene Flushing Box 2 is blinking till
first commissioning.
1
Install KEMPER HS2 app on your
smartphone. Scan QR code or go
to hs2app.kemper-olpe.de
install.
2
Start KEMPER
perform the following steps.
3
Connect smartphone to KHS Hygiene
Flushing Box 2 via Bluetooth.
4
Enter the menu <hardware setup>.
Check the settings and change them if
required.
5
Enter the menu <operating
modes>. Configure the
operating times.

External control

The KHS Hygiene Flushing Box 2 can be
activated externally via a KHS Mini System
Control or a building management system.
In this case, a direct configuration is not
required. The KHS Hygiene Flushing Box 2 can
be set up and operated by the external control.
KEMPER KHS HS2
QR-code). The app
.
to
HS2 app and
For more
external control,
documentation of the KHS Mini System
Control and Connection kit's, as well as
the data sheet External Control.
Deactivating the Bluetooth interface
It is possible to deactivate the Bluetooth interface.
To do this, when the supply voltage is switched on,
the test button on the KHS HS2 must be pressed
and held for about 2 seconds. A successful
deactivation is indicated by means of a short beep
(approximately 1 second) after the startup and
displayed as an LED signal (see the display of the
operating status).
Activating the Bluetooth interface
The same procedure as for deactivation.

Factory settings

If no operating times are configured , the KHS
HS2 hygiene flushing box works with the
following factory settings.
Parameter Description
Flushing
Time between two
interval
flushings
Flushing Duration of a flush
time
Start time Time of flushing
It is recommended to set up a project specific
program for the KHS Hygiene Flushing Box 2,
as each water installation
characteristics.
21
EN
information about the
please see the
Value
48 h
5 min
7 am
has different