Additional Controls - SEAL 80 Pro Manuel D'utilisation

5.1.3 Additional controls

Figure 12: Additional controls
Emergency stops (1),
Stop buttons (1a), push and hold button;
When pressed the rotation of the rollers is stopped immediately and the button is locked
into this stop position.
Turn the button to unlock it.
Pressing start, reverse or pressing the footswitch starts the process again.
Trip wire (1b), wire attached to a pull and hold switch;
When the wire is pulled or stept on the switch will immediately stop the rollers. The switch
is locked in this position and has to be pulled before the machine can be started again.
Contol panel arm (2),
Figure 13: Control panel arm
Operating
The arm can swing (A) 180° over the machine from front to rear
and back, within the width of the machine.
The control panel is mounted on an extendable arm. By pulling the
grips the arm can be extended (B) approximately 27cm.
The panel assembly can rotate (C) within a limited radius of 90°.
25