Customer Service - Dimplex DEE 1803 Notice De Montage Et D'utilisation

Fault
The appliance does not start
(heat), no water flows.
If the fault could not be eliminated, please call customer service.

Customer Service

We ask you to always provide the E-No. and the FD-No. of
your appliance when calling in a customer service engineer.
E-No.:
FD-No.:
Disposal
This appliance is labelled in accordance with Euro-
pean Directive 2002/96/EG concerning used elec-
trical and electronic appliances (waste electrical
and electronic equipment – WEEE).
The guideline determines the framework for the
return and recycling of used appliances as applica-
ble throughout the EU.
Please ask your specialist retailer about current dis-
posal facilities.
Guarantee
The guarantee conditions for this appliance are as defined by
our representative in the country in which it is sold.
Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of
sale or receipt must be produced when making any claim
under the terms of this guarantee.
Subject to change without notice.
12
EN
Cause
Power failure or initial start-up.
Solution
Starts rinsing:
Open the warm water tap and
allow water to flow for at least
1 minute (flow-rate at least 6 litres
per minute). Only then (for safety
reasons) will the appliance begin
to heat.
Should the appliance not start
because of a reduced flow-rate,
remove the perlator, shower head
or similar before start and repeat
the process.
Who
Customer