Options; Multitab Function; Acoustic Signals - AEG FAVORIT 54000 VI Notice D'utilisation

28

OPTIONS

MULTITAB FUNCTION

Activate this function only when you use
the combi detergent tablets.
This function deactivates the flow of rinse
aid and salt. The related indicators are off.
The programme duration can increase.
Activating the multitab function
Activate or deactivate the multi-
tab function before the start of a
programme. You cannot activate
or deactivate this function while a
programme operates.
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
3. Press the multitab button, the multitab
indicator comes on.
The function stays on until you de-
activate it. Press the multitab but-
ton, the multitab indicator goes
off.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Deactivate the multitab function.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse
aid.

ACOUSTIC SIGNALS

The acoustic signals operate in these con-
ditions:
• The programme is completed.
• The level of the water softener is adjus-
ted electronically.
• The appliance has a malfunction.
Factory setting: on. You can deac-
tivate the acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
3. Press and hold function buttons (B)
and (C) at the same time until the indi-
cators of function buttons (A), (B) and
(C) flash.
4. Press function button (C),
• The indicators of function buttons
(A) and (B) go off.
• The indicator of function button (C)
continues to flash.
• The end indicator comes on.
5. Press function button (C). The end in-
dicator goes off, the acoustic signals
are deactivated.
6. Deactivate the appliance to confirm.
Activating the acoustic signals
1. Refer to 'Deactivating the acoustic sig-
nals', step (1) through (3).
2. Press function button (C),
• The indicators of function buttons
(A) and (B) go off.
• The indicator of function button (C)
continues to flash.
• The end indicator is off.
3. Press function button (C). The end in-
dicator comes on, the acoustic signals
are active.
4. Deactivate the appliance to confirm.