Nakayama EH 500 Traduction De La Notice Originale page 11

Do not operate the tool if your mind is not on
your work.
18. Check the tool for damage
- Each time before re-using the tool, carefully
check that the guards or any slightly damaged
parts are working as intended. Check that the
moving parts are in good working order, that
they do not jam, and that no parts are damaged.
Make sure that all parts are fitted correctly and
that all other operating conditions are properly
fulfilled. Unless otherwise stated in the operating
instructions, damaged guards and parts have to
be repaired or replaced by an authorized service
center. It is imperative to have damaged switches
repaired by an authorized service center. Never
use any tool if its switch cannot be turned off and
on.
19. Important!
- For your own safety, use only accessories and
attachments which are listed in the operating
instructions or recommended or listed by the
tool manufacturer. The use of any accessory or
attachment other than those recommended
in the operating instructions or catalogue may
involve a risk of injury for you personally.
20. Have repairs carried out only by a qualified
electrician
- This electric tool complies with the pertinent
safety regulations. Repairs are to be carried out
only by a qualified electrician or the user may
suffer an accident.
21. Replacing the power cable
To prevent injury, damaged power cables may
only be replaced by the manufacturer or the
customer service center.
22. Noise
- The noise level of this electric tool is measured
in accordance with ISO 3744 and NFS 31-031
(84/537 EWG). Noise at the workplace may
exceed 85 dB(A). In this case, the operator must
wear ear-muffs or similar.
Keep these safety instructions in a safe
place.
Specific safety information
Please read this safety information and the
directions for use carefully and be sure to follow
the instructions to the letter.
1. Always remove the power plug from the
socketoutlet before you perform any work on the
hedge trimmer, e.g.
- repairing a damaged cable
- cleaning the blades
- troubleshooting
- cleaning and maintenance
or before leaving the tool unattended.
2. The hedge trimmer can cause serious injuries!
Read the directions for use carefully in order to
acquaint yourself with the correct way to handle,
set up, service, start and put down the
machine. Familiarize yourself with all the
machine's control elements and its proper use.
3. Always handle the hedge trimmer with both
hands.
4. When working with the hedge trimmer, wear
sturdy shoes and make sure of your footing.
5. Never work with the hedge trimmer in the rain
or on wet hedges and never leave the hedge
trimmer outdoors. The hedge trimmer must not
be used if it is wet.
6. We recommend that you wear safety goggles
and ear-muffs when working with the hedge
trimmer.
7. Wear suitable working clothes such as rubber
gloves and non-slip shoes. Do not wear loose
garments. Keep long hair in a hairnet.
8. Avoid abnormal postures and make sure of
your footing, particularly when working on
ladders and steps.
GB
11