How To Use In Dvd Mode - ALDEN ALD-13960 Guide D'installation Et D'utilisation

6. Your TV is now installed. To use the system in DVB-S satellite mode: Press « source>TNT », you can see a pre
programmed channel list by pressing Enter . To switch to DVB-T mode, refer to «channel» menu. Choose
«Connection TV» and select «antenna» mode, then launch a search for a satellite, by refering to chapter
«Automatic channel search». (pages 57 and 58)
How to use in terrestrial mode
Important information :
Since november 30th 2011, no more analog signal is broadcasted in France.
Press Source to display the list of video sources. Use
- A TV to watch analog programmes (no longer used)
- DTV to watch digital programmes (terrestrial or satellite)
then press Enter to confirm your choice.
When watching a programme, the main following features are available :
• Ch+/- : go to the next / previous programmes
• 0...9 : display a programme by entering the number.
• Vol+/- : increase / lower the volume.
• Fav : display the favorite channel lists.
• EPG : display the EPG ( Tnt source only ).
• Display : press once to display limited information, press twice to display all the information corresponding
to the watched programme, press a third time to remove the display. .
• TV/radio : switch between TV and Radio mode ( TNT source only).
Other features are available in terrestrial televison mode. Refer to the following pages 50 and 51.
How to use with an external satellite receiver
Press Source to display the list of video sources. Use
- AV if your satellite receiver is connected to the TV with a RCA cable
- Scart if your satellite receiver is connected to the TV with a scart cable.
- YPbPr if your satellite receiver is connected to the television via a YUV cable (blue - green - red)
- HDMI if your satellite receiver is connected to the TV with a HDMI cable.
then press Enter to confirm your choice.
Then refer to the instructions given with your receiver and satellite system to go further.
Information :
Each time you switch the system on, the TV will automatically select the last chosen source.
The AV and HDMI sources are direclty accessible by pressing the corresponding buttons.

How to use in DVD mode

Important information :
Handling a DVD can only be done once the DVD mode has been selected. It is not possible to insert or eject a
DVD if another mode is selected.
Press Source to display the list of video sources. Use
choice. The DVD player will unlock.
Insert the DVD in the DVD player, printed side towards the back of the TV. The DVD will start automatically.
Use to navigate in the interractives menus and confirm your choice by pressing Enter .
Other functions are available in DVD mode . See the coming pages 50 and 51.
ALD-13960
and to select :
and to select :
(white - yellow - red)
and to select DVD then press Enter yo confirm yur
.
53