Table des Matières
Publicité
disconnector switch (with at least 3 mm
contact spacing) must be used in order
to meet the safety regulations.
•
The fused switch must be easily
accessible once the appliance has been
installed.
•
Ensure all connections are adequately
tightened.
•
Fix the supply cable in the cable clamp
and then close the cover.
•
The terminal box connection is placed
on the terminal box.
N
PE
4
5
3
2
1
L3
L2
L1
N
PE
4
5
3
2
1
L
EN - 11
2.6 PoWer SuPPly ConneCtion
1
4
6
6
For establishing the power supply
connection for the appliance;
•
Connect the air extraction control unit
data cable (2) with the data cable from
the control box (3).
•
Plug the main cable of the hob (1) into
the socket (5).
•
Plug the main cable of the control box
(4) into the socket (5).
•
Plug the motor connection cable (6)
from the control box into the socket on
the motor unit.
2.7 inStallation DiMenSionS
•
Cut the aperture dimensions as
indicated in the figure. Locate the
aperture on the worktop so that, after
the hob is installed, the following
requirements are followed.
2
5
3
5
1
4
2
3
Publicité
Chapitres
Table des Matières
Dépannage
