Table des Matières
Publicité
5. Control Box
6. Assembling kit
7. Motor unit
8. Activated charcoal filter housing
9. Activated charcoal filter
10. Activated charcoal filter cover
2.3 aSSeMblyinG of the
air extraCtion unit
Assemble the air extraction unit towards
the induction hob bottom cover. Use firstly
the screws (1) and washers (3), then the
screws (1) and the washers (3) included in
the assembling kit.
3
2
2.4 inStallation of the VentinG hob
The appliance is supplied with an
installation kit including adhesive sealing
material, fixing brackets and screws.
•
5
•
6
7
2.5 eleCtriCal ConneCtion anD Safety
8
qualified electrician, according to the
instructions in this guide and in compliance
9
with the current local regulations.
10
•
•
1
•
2
•
•
EN - 10
Apply the supplied one-sided self-
adhesive sealing tape "1" all the way
around the lower edge of the cooktop.
Do not stretch the tape.
Screw the 4 worktop mounting brackets
"2" in to the side walls of product.
1
2
WARNING: The electrical connection
of this appliance should be carried out
by an authorised service person or
WARNING: THE APPLIANCE MUST
BE EARTHED.
Before connecting the appliance to the
power supply, the voltage rating of the
appliance (stamped on the appliance
identification plate) must be checked for
correspondence to the available mains
supply voltage, and the mains electric
wiring should be capable of handling the
appliance's power rating (also indicated
on the identification plate).
During installation, please ensure
that isolated cables are used. An
incorrect connection could damage
your appliance. If the mains cable is
damaged and needs to be replaced this
should be done by a qualified person.
Do not use adaptors, multiple sockets
and/or extension leads.
The supply cord should be kept away
from hot parts of the appliance and must
not be bent or compressed. Otherwise
the cord may be damaged, causing a
short circuit.
If the appliance is not connected
to the mains with a plug, a all-pole
Publicité
Chapitres
Table des Matières
Dépannage
