Air Extraction Unit Controls - Burg BML78 Manuel D'utilisation

Error Codes
If there is an error, an error code will be shown on the
heater displays.
E1
Cooling Fan is disabled. Call an authorised
E3 Supply voltage is other than the rated values.
Switch the hob off by pressing
"H" disappears for all zones, switch the hob
on by pressing
the same error is displayed again, call an
authorised service agent.
E4 Supply frequency is different from the rated
values. Switch the hob off by pressing
, wait until "H" disappears from all
zones, switch the hob on by pressing
and continue to use. If the same error is
displayed again, switch the plug for the
appliance off and on. Switch the hob on by
pressing and continue to use. If the same
error is displayed again, call an authorised
E5 Internal temperature of the hob is too high,
switch the hob off by pressing
heaters cool down.
E6
Communication error between the touch
control and heater. Call an authorised service
E7 Coil temperature sensor is disabled. Call an
authorized service agent.
E8 Cooler temperature sensor is disabled. Call
an authorized service agent.
EA
Large Coil Saturation Error. Switch the hob
off by pressing on/off button, switch the hob
on by pressing on/off button and continue to
use. If the same error is displayed again, call
an authorised service agent.
EC
Supply Voltage Error.Switch the hob off by
pressing on/off button, switch the hob on by
pressing on/off button and continue to use.
If the same error is displayed again, call an
authorised service agent.
C1-C8
Mcroprocessor alert. Switch the hob off by
pressing on/off button, switch the hob on by
pressing on/off button and continue to use.
If the same error is displayed again, call an
authorised service agent.

4.2 air extraCtion unit ControlS

1
2
1- Air extraction unit On/Off
2- Decrease fan level setting
service agent.
,wait until
and continue to use. If
service agent.
and let the
agent.
3
5
4
3- Fan level display
4- Increase fan level setting
5- Timer selection
Switching the Air Extraction Unit On-Off
When the device is not in operation, the
digital display
appears as a dot. As soon as any button
is pressed, a flashing "L" (i.e. lock) appears
3 times on the digital display.
After that, press and hold down the timer
button until "0" appears on the digital
display.
The fan has been unlocked.
After unlocking the fan, you can use the "+"
and "-" buttons to set the speed of the fan.
Now setting up the fan operation speed is
completed.
Switching the Air Extraction Unit Fan
Level On
Increase the fan speed by pressing the
button "+". Fan level has been increased.
Switching the Air Extraction Unit Level
Off
Decrease the fan speed by pressing the
button "-". Fan level has been decrease.
If for 10 minutes, no button has been
pressed, the device will switch into the
standby mode and get locked.
To turn off the fan, press the button
until "0" appears on the digital display.
Timer Function
If while the device is running on any level,
the button is pressed, the 15 minutes timer
will be activated. As soon as the timer starts
counting down, the speed value on the
digital display will start flashing. After 15
minutes, all functions that were activated
prior to the timer, will shut down.
Press the Timer button
Delayed shut-off automatic has been
activated.The fan will automatically shut
down after 15 minutes.
When the delayed shut-off automatic
has been activated, the speed value
on the digital display will start flashing.
Press the sensor button
Delayed shut-off automatic has been
deactivated.
EN - 24
is in standby mode and
.
again.