Electrical Connection; Electrical Connection Of Your Hob - Burg BCA60-TR Instructions D'utilisation Et D'installation

Masquer les pouces

Table des Matières

Les langues disponibles

Electrical connection of your hob

· Before proceeding with the electrical connection, verify that the current

carrying capacity of the system and the socket is adequate for the maximum

power rating of the hob.

· Electrical installation of the residence and the electrical current plug in

use must be earthed and conform with safety regulations.

· If there is no dedicated hob circuit and fused switch, they must be installed

by a qualified electrician before the hob is connected.

· The fused switch must be easily accessible once the hob has been

installed.

· Do not use adaptors, multiple sockets and/or extension leads.

· This appliance conforms with the requirements ofthe following EEC

Directives:

1. Vitroceramic hob EEC/73/23 and 93/68, EEC/89/336 relating to

radio interference,

2. EEC/89/109 relating to contact with foods.

· A circuit breaker with a contact opening of at least 3 mm, rated 32A and

delayed functioning type must be installed in the supply circuit.

3x2,5 mm² 220V~

3x2,5 mm² 230V~

3x2,5 mm² 240V~

Supply cable connection can be differ according to terminal box type.

· The supply cable must be H05VV-F 3X2,5 mm² / 60227 IEC 53. You will

find the connection diagram shown on the back of your appliance.

· During installation, please insure that isolated cables are used. An incorrect

connection might damage your appliance. The guarantee will not cover

such damages.

· All repairs must be carried out by an authorised service personal or a

qualified electrician.

· Unplug your appliance before each maintenance. For reconnection, follow

the connection diagrams.