Electrical Connection Of Your Hob - Burg BCA60ZKB-R Instructions

Electrical connection of your hob

• Before proceeding with the electrical
connection, verify that the current car-
rying capacity of the system and the
socket are adequate for the maximum
power rating of the hob.
• Electrical installation throughout the
residence and the electrical current
plug in use must be earthed and con-
form with safety regulations.
• If there is no dedicated hob circuit and
fused switch, they must be installed
by a qualified electrician before the
hob is connected.
• Fused switch must be easily accessi-
ble once the hob has been installed.
• Do not use adaptors, multiple sockets
and/or extension leads.
• A circuit breaker with a contact open
ing of at least 3 mm, rated 25 A and
delayed functioning type must be in
stalled inside the supply circuit.
• For the touch=controlled vitroceram
ic hob, the cable must be H05VV-F
3X2,5 mm² / 60227 IEC 53. You will
find the connection diagram shown on
the back of your appliance.
• During installation, please ensure that
insulated cables are used. An incor
rect connection might damage your
appliance. The warranty will not cover
such damages.
• All repairs must be carried out by au-
thorised service personnel or a quali-
fied electrician.
• Unplug your appliance before each
maintenance. For reconnection, fol-
low the connection diagrams exactly.
3x2,5 mm² 220V~
3x2,5 mm² 230V~
3x2,5 mm² 240V~
-
3x2,5 mm² 220V~
3x2,5 mm² 230V~
3x2,5 mm² 240V~
Supply cable connection can be differ
according to terminal box type.
-
EN -8-
5x1.5 mm² 380V 3N~
5x1.5 mm² 400V 3N~
5x1.5 mm² 415V 3N~
/
5x1.5 mm² 380V 3N~
5x1.5 mm² 400V 3N~
5x1.5 mm² 415V 3N~