Important - Beta 599DGT-A/10 Mode D'emploi

– Usually press
ATTENTION:
If an external force is applied to the torque wrench during the power-on/reset or wake up period, an
initial torque offset will be found in the memory.

IMPORTANT:

When the wrench is used in the "angle" mode, it should be placed horizontally on a plane before any
values are changed. If this instruction is not followed, a set of angle indicators will start blinking on the
dial:
ACTIVATION DURING SLEEP MODE
– The wrench will auto sleep after about 5 minutes idle for power saving.
Press to wake up the wrench during the sleep mode.
RESETTINGWRENCH
– If the wrench does not function normally, press
LOW BATTERY VOLTAGE PROTECTION
– If the battery voltage is under 2.3 volts, the wrench will display a battery symbol and then turn off
after a while.
SETUP
1 - Value storage
2 - Set Torque Value
3 - Unit Selection/Setting
4 - Power On/Clear
to reset the digital torque wrench before using it.
To start the wrench, press
together to reset the wrench.

1


4
2

3
15