Beta 599DGT-A/10 Mode D'emploi page 18

PEAK HOLD MODE OPERATION
Max. Target Value
Current Max. Value
Note:
1. If appears, that means more than 110% of torque as stated in the specifications has been
applied to this wrench.
The wrench will start working again after a few seconds; however, it should be checked for
calibration at a Beta authorized centre as soon as possible.
2. The green LED will be on for 90% of maximum setting torque.
3. The red LED will be on for 100% of maximum setting torque.
18
START
(System initial)
* Note 1
Apply Torque
Released
Apply Torque
(Peak Hold)
Over 90% of Max. Target Value
* Note 2
Buzzer
Reach Max. Target Value
* Note 3
Buzzer
Flashing
Green LED
Reach 90% of Set Torque
Red LED
Reach Max. Set Torque