Cleaning And Maintenance; Technical Specifications - HQ Power VDL660LON Mode D'emploi

• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
a) Lamps
• Only fit or replace a lamp when the device is unplugged from the mains.
• Let a lamp cool down before replacing it.
• Do not install lamps with a higher wattage than that for which this device was designed.
• Replace any deformed or damaged lamp with a lamp of the same type.
b) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Make sure there is no flammable material within a 50cm radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
All controls are on the centre module. Switch the device on and off by means of the ON/OFF switch. Do not operate
the device continuously.
Adjust the sensitivity of the 3 channels (2 opposed lamps compose 1 channel) by means of the 3 rotary controls
(bass, middle and high – each channel reacts to a different frequency area) until the reaction of the lamps to the
music satisfies you.

6. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing and the installation location should not be deformed, modified or tampered with.
3. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
4. Disconnect the device from the mains prior to maintenance activities.
5. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
6. There are no user-serviceable parts, apart from the lamp (see "4. Installation").
7. Contact your dealer for spare parts if necessary.

7. Technical Specifications

Power Supply
Dimensions
Total Weight
Lamp
blue
green
orange
red
violet
yellow
Max. Ambient Temperature
The information in this manual is subject to change without prior notice.
VDL660LON
max. 230Vac/50Hz
∅330 x 180mm
2.8kg
6 x 230V / 60W E27 R80
LAMP60B
LAMP60G
LAMP60O
LAMP60R
LAMP60V
LAMP60Y
45°C
2 VELLEMAN