LENCO LS-500 Mode D'emploi page 10

Needle: AT-3600L
Frequency Response
Channel Balance
Channel Separation
Output Voltage
Recommended Load Resistance
Amplifier connection
Recommended Tracking Pressure
Weight
Note:
•
Design and specifications are subject to change without notice.
Power supply adaptor:
Manufacturer: Brightpower Optoelectronic Technonlgy Co., Ltd.
Model Number: SW1502400-IM/ S036A1502400M
Input voltage: 100-240V
Input AC frequency:
Output voltage: DC 15V
Output current: 2.4A
Output Power: 36W
Average active efficiency:
Efficiency at low load (10%): 84 %
No load Power consumption: 0.080W
Use only the power supply listed in the user instructions
Turntable Maintenance
Do not touch the stylus tip with your fingers. Avoid bumping the stylus on the turntable mat or a record's
1.
edge.
Clean the stylus frequently with a soft brush with a back-to-front motion only.
2.
Clean the records to get rid of dust or grease with a record cleaning brush and record cleaning solution.
3.
Clean the turntable lid and turntable cabinet with a slightly damped microfiber cloth.
4.
Note: Do not use cleanser other that contains alcohol,benzene or any other harsh chemicals, with might damage
the paint and finish of the turntable.
Troubleshooting
There is no power
• Power adaptor is not connected correctly.
• No power at the power outlet.
Power is on, but the platter does not turn
• This unit is not in turntable mode. Press the MODE button to turntable mode, the indicator light in red.
• Need to press the PLAY/STOP button once to start playing.
• Turntable's drive belt is not installed or has slipped off.
20Hz - 20kHz
<2.5dB
>18dB
2.5mV
47kΩ
MM - input
3.0±0.5g
5g
50/60Hz
87.58%
- 10 -