Pattfield Ergo Tools PE-650 FS Traduction De La Notice Originale page 89

INSERT CUTTING WHEEL
1 Remove the bevel cutting guide 12. Un-
screw and take out the lower guard, the
outer flange and the screw.
Caution! Make sure the tool is
switched off and unplugged and
wear protective gloves.
3 Fasten the screw tightly with the de-
livered wrenches. Refit the lower guard
and the bevel cutting guide 12.
PARALLEL CUTTING GUIDE
1 Fit the components of the parallel cut-
ting guide 11 together and place it on
the work table 10. Fasten tightly with
the parallel guide lock knob 7.
BEVEL CUTTING GUIDE
3 For bevel cuts of 15°, 30° or 45° lift the
bevel cutting guide 12, swing the sup-
ports on its lower side to the outsides
and fix them securely into the corre-
sponding openings on the rear wall of
the tool in the desired height.
FILLING THE WATER TANK
1 Make sure the water tank is filled be-
fore cutting. Take off the bevel cutting
guide 12. Put the stopper into the drain
and fill water into the tank. Ensure, that
the wheel is not submerged in water to
more than 1/4 th. After cutting, take out
the stopper and let the water drain off.
2 Fit the cutting wheel 2, the flange and
the screw on to the shaft.
Caution! Observe that the rotation
direction of the cutting wheel corre-
sponds with the indication on the flange.
4 Fasten the upper cutting wheel guard
to the guard holder.
MITRE CUTTING GUIDE
2 Fit the mitre cutting guide
allel cutting guide 11. Open the mitre
lock knob 4. Set the desired angle and
tighten the mitre lock
Caution! Stop the tool immediately
when detecting unusually strong vi-
brations or other defects.
Caution! Never pour any chemicals
or solvents into the water.
1
5 on the par-
knob 4 securely.
EN 87