Pattfield Ergo Tools PE-650 FS Traduction De La Notice Originale page 86

unguarded cutting wheel.
- Perform cuts correctly and safely:
a) Ensure before each cut that the table is
stable.
b) Support long workpieces with the work
table extension if needed.
c) Provide adequate general or localized
lighting.
d) The operator is adequately trained in
the use, adjustment and operation of the
machine.
e) Use correctly sharpened cutting wheels.
Observe the maximum speed marked on
the tile cutter.
f) Replace table insert when worn.
Remove the plug from the socket before car-
rying out any adjustment, servicing or main-
tenance.
1. Only tiles can be cut with this tile cutter.
Other materials may shatter or cause the
cutting wheel to grab.
2. Never fit substandard blades. Only fit cor-
rectly sized cutting wheels.
3. Let the cutting wheel reach full speed be-
fore commencing the cut.
4. Do not use damaged or worn cutting
wheels.
5. Ensure that the direction arrow marked on
the cutting wheel corresponds with the ro-
tational direction of the motor.
6. Ensure the movable guard operates freely
without any jamming .
7. Never cut pieces too small to be held se-
curely against the guides. Leave enough
space for the hand to be a safe distance
from the cutting wheel.
8. Regularly check the cutting wheel secur-
ing bolt.
9. Do not run the machine with any part of
the casing missing or damaged.
10. Do not start the tile cutter when the cut-
ting wheel is inserted into the workpiece.
11. Before cutting let the cutting wheel run
freely for a few seconds. If it makes an un-
familiar sound or vibration switch it off im-
mediately and disconnect from the power
supply.
84 EN
12. Never try to cut free hand. Always ensure
that the workpiece is securely pressed
against the corresponding guide.
13. Do not forget to remove any adjustment
keys, spanner and wrenches before
switching on the tool.
14. When the machine is operating, keep
hands away from the cutting area.
15. Always ensure the safety guard is in work-
ing order before use. Should the guard not
close quickly over the cutting wheel, do
not use the tool.
16. Only use cutting wheels with the correct
bore size for the spindle.
17. Keep the power cord well away from the
cutting area during use. Always position
the cord so that it will not be caught in the
workpiece when the tile cutter is in use.
18. Always connect the tool to a supply circuit
secured with a residual current device
(RCD).