Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
extension cords intended for outdoor use
and so marked.
19. Stay alert
- Watch what you are doing, use common
sense and do not operate the tool when
you are tired.
20. Check damaged parts
- Before further use of tool, it should be
carefully checked to determine that it will
operate properly and perform its intended
function.
- Check for alignment of moving parts,
binding of moving parts, breakage of
parts, mounting and any other conditions
that may affect its operation.
- A guard or other part that is damaged
should be properly repaired or replaced by
an authorised service centre unless other-
wise indicated in this instruction manual.
- Have defective switches replaced by an
authorised service centre.
- Do not use the tool if the switch does not
turn it on and off.
21. WARNING: The use of any accessory or
attachment other than one recommended
in this instruction manual may present a
risk of personal injury.
22. Have your tool repaired by a qualified per-
son
- This electric tool complies with the rel-
evant safety rules. Repairs should only
be carried out by qualified persons using
original spare parts. Otherwise this may
result in considerable danger to the user.
23. If the replacement of the supply cord is
necessary. This has to be done by the
manufacturer or his agent in order to avoid
a safety hazard.
ADDITIONAL SAFETY INSTRUCTIONS ON
RISKS DUE TO VIBRATION
a) The declared vibration data represents
the main applications of the tool, but
different uses of the tool or poor main-
tenance can result in different vibration
data. This may significantly increase the
vibration level over the total working period.
b) Additional safety measure shall be taken
to protect the user from effects of vibra-
tion. Maintain the tool and its accessories,
keep hands warm and organize work pat-
terns and periods.
ADDITONAL SAFETY INSTRUCTIONS FOR
TILE CUTTERS
Safety precautions
-
WARNING: Do not use cutting wheels
which are damaged or deformed .
-
Replace the table insert when worn.
-
Use only cutting wheels recommended by
the manufacturer which are conform to
EN 13236.
-
Wear suitable personal protective equip-
ment when necessary, this could include:
a) Hearing protection to reduce the risk of
induced hearing loss.
b) Eye protection when using the tool.
c) Respiratory protection to reduce the risk
of inhalation of harmful dust .
d) Gloves for handling cutting wheels (cut-
ting wheels shall be carried in a holder
wherever practicable) and rough material.
Safe operation
-
Select the correct cutting wheel for the
material to be cut.
-
WARNING: Do not use the cutting wheel to
cut other materials than those specified.
-
Lift and transport the tool only at its trans-
portation handle with the upper cutting
wheel guard closed.
-
Do not use the tile cutter without the
guards in position, in good working order
and properly maintained.
-
Keep the floor area around the machine
level, well maintained and free of loose
materials e.g. chips and cut-offs.
-
Ensure that the speed marked on the cut-
ting wheel is at least equal to the speed
marked on the tile cutter.
-
Ensure that any spacers and spindle rings
used are suitable for the purpose as stated
by the manufacturer.
-
Refrain from removing any cut-offs or oth-
er parts of the workpiece from the cutting
area whilst the machine is running with an
EN
83
Publicité
Chapitres
Table des Matières
