Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Product overview
1
Upper cutting wheel guard
2
Diamond cutting wheel
3
Work table extension
4
Mitre lock knob
5
Mitre cutting guide
6
Handle
7
Parallel guide lock knob
8
ON and OFF switches
9
Power cable
10
Work table
11
Parallel cutting guide
12
Bevel cutting guide
Intended Use
The tool is intended for cutting mitre (0° to
45°) and/or bevel (15°, 30°, 45°) cuts in firmly
supported tiles. The tool is not intended for
commercial use.
Any other use (e.g. abrasive wheels) or modi-
fication to the tool is considered as improper
use and could cause considerable dangers.
The delivered cutting wheel is intended for use
with tiles only!
GUARD HOLDER
1
Take out the bevel cutting guide
unfasten screw. Fit the guard holder
under the screw and fasten it.
86
EN
Using the tool
1. Place the tool on a clean, plain and stable
underground.
2. Plug the tool to a suitable socket outlet.
3. Push the green ON switch |
until the cutting wheel
full rotation speed.
4. Adjust the cutting guides
cording to the desired dimensions, hold
the tile firmly to the guide and push it
smoothly through the cutting wheel 2.
Push downwards to avoid the tile from
lifting during the process.
5. Push the red OFF switch
off the tool. Wait until the cutting wheel
has stopped completely before removing
the workpiece or making adjustments.
Caution! Make sure the electric
supply meets the requirements
specified in the technical data.
WORK TABLE EXTENSION
12
and
2
Take out the screws in the work table
extension 3, attach it to the tool in the
desired length and fix it with the lock
knob.
Caution! Make sure the tool is
switched off and unplugged.
8
and wait
2
has reached its
4, 11
or
12
ac-
◦
8
to switch
2
Publicité
Chapitres
Table des Matières
