Bodum Bistro 11451 Mode D'emploi page 4

– Scalding may occur if the lid is removed during the brew-
ing cycles.
– If the kettle is overfilled, boiling water may be ejected.
– Do never boil water without the lid on.
– Always ensure that you pour out boiling water slowly and
carefully, taking care not to tilt the spout too rapidly.
– To prevent scalding, avoid coming into contact with the
steam escaping from the opening in the lid when the
water is being boiled or just after the kettle has switched
off. Be careful when opening the lid, if the kettle is still hot
and you wish to refill it with water.
– Boiling water can cause burns.
– Move the appliance with extreme care when it contains
hot water.
– Do not forcefully locate the switch in the ON position, or
make any authorised changes to the switch in order to
make it stay in the ON position. This could lead to steam
escaping from around the lid, damaging the automatic
switch-off mechanism and possibly causing bodily injury.
– Never immerse the item in water, remember this is an elec-
trical appliance.
– Only clean the appliance using a damp cloth.
– To disconnect, turn any control to «off» then remove plug
from wall outlet.
– Always unplug the appliance by holding the plug, not the
cord.
– Do not let cord hang over edge of table or counter, or
touch hot surfaces.
– Unplug the power cord from the wall outlet when the
kettle is not in use and before cleaning. Allow the kettle
to cool before putting on or taking off parts and before
cleaning it.
– Do not operate any appliance with a damaged cord
or plug or after the appliance malfunctions, or has
been damaged in any manner. Return appliance to the
nearest authorized service facility for examination, repair
or adjustment.
– In order to avoid hazard never attempt to exchange the
mains cable of the appliance as special tools are required
for this. To ensure continued safety of the appliance, if the
cable needs to be repaired or exchanged, have this carried
out exclusively by a customer service workshop authorised
by the manufacturer.
– To protect against fire, electric shock and injury to
persons do not immerse cord, plug, kettle container and
power base in water or other liquid.
76