Kyocera TJEP Manuel D'utilisation page 10

Daily maintenance/precautions
Before you start, make sure the air pressure is correct. The maximum air pressure is specified on the tool.
Keep the tool clean.
Make sure that you use the correct staples before you start. Use only staples specified by the manufacturer.
Empty the water separator for the compressor daily.
Make sure that the tool is maintained regularly.
Make sure to grease the tool with the correct lubricant.
Cut off the air supply and empty the magazine when the work is done.
Make sure that the magazine is tightened properly.
If the tool behaves unusually, cut off the air supply immediately.
NB: All the above-mentioned precautions are pivotal in regards to safety, the tool's functionality and the lifetime of
the tool.
10