Maverick STRADA Manuel D'utilisation page 12

Changing the setup
The ESC has a number of programmable modes that can be altered to suite a variety of functions. Each set of green
LED fl ashes/beeps represents the programmable mode (1 fl ash = Running mode, 2 fl ashes = Drag brake force and
3 fl ahes = Auto-lipo settings etc..) and each set of red LED fl ashes/beeps represents that modes value. See the
table below for all the programmable modes and their values. When you enter the setup mode you need to keep the
button pressed until you enter the desired programme mode (green fl ashes/beeps). Once you reach that mode
release the button and that will allow you to change the mode value (red fl ashes/beeps). You need to switch off the
ESC to save the settings then re-do the process to change to a different mode or mode value setting. If you lose
your way with setup then you can return the unit to default settings by turning on the ESC, keeping the transmitter in
neutral and pressing the setup button for 3 seconds. Both red and green LED's will fl ash together 3 times to confi rm
this.
While switching on the ESC hold down the setup button. Continue to hold the
setup button while the red LED fl ashes.
Continue to hold the setup button until the green LED starts to fl ash.
Each green LED fl ash represents the programmable mode number.
Release the setup button when you reach the desired mode. You are now in the program mode setting.
Press the setup button to change the mode value. Each mode
value will have different amounts of red LED fl ashes.
Resetting Default Values
The ESC can be reset to it default settings at any time. When the ESC is on (not in Setup Calibration or
Programmable Settings modes) and the throttle is in the neutral position, hold the setup button for more than 3
seconds. The red and green LED's will fl ash at the same time 3 times to indicate that the defaults have been reset.
LED
1 red LED fl ash
LED LED
represents the
"No Protection" setting
LED
LED LED
In order to save the changes and settings
you must switch off the ESC. When you next
switch it back on it will have saved your new
settings. To make further alterations you
need to re-enter the mode values again.
12
LED LED
Red LED fl ashes for 4 seconds.
Green LED will begin to fl ash.
3 green LED fl ashes
represent the Low
LED LED LED LED LED
Voltage Cut-Off setting
for example.
LED