Maverick STRADA Manuel D'utilisation page 11

Programmable Mode Settings
PROGRAM
PROGRAMMABLE VALUE
Forward with
1. Running Mode
2. Drag Brake Force
3. Low Voltage Cut-off
4. Start Mode (Punch)
5. Max Brake Force
Running Modes FWD w/Brake
Fwd/Rev/Brake This mode offers forward, brake and reverse. Note, The reverse uses a soft
Drag Brake Force
Low Voltage Cut-Off
Start Mode (Punch)
Max Brake Force
1 2
Forward/
Reverse
Brake
with Brake
0% 5% 10%
Non-
2.6V/cell 2.8V/cell
Protection
Level 1
L2
(Soft)
25% 50% 75%
This mode is for forward and brake only
start "Double Click" function which will only allow reverse to be activated once
the motor has stopped moving forwards.
This allows the setting of an automatic drag brake when the throttle stick is
returned to neutral, simulating the slight braking effect of a brushed motor while
coasting.
If the voltage of a LiPo battery pack is lower than the threshold, The ESC will
cut off the output power. Please note that the ESC cannot be restarted if the
voltage of each LiPo cell is lower than 3.5V. For NiMH battery packs,if the
voltage of the whole NiMH battery pack is higher than 9V but lower than
12V then it will be considered as a 3S LiPo; If it is lower than 9V it will be
considered a 2S LiPo.
This mode selects the level of "punch" from a standing start.Level 1 is soft,
right up to level 4 which is very aggressive. Please note, If levels 3-4 are
selected, battery packs with low discharge rates or are poor quality will not
be able to supply the needed power. It can also cause the motor to not run
smoothly or tremble.
The ESC provides a proportional brake function. This mode sets the brakes
force applied when the throttle is at full brake. A very large brake force may
slow the car quickly but be aware it can also do damage to the cars drivetrain.
3 4 5
15% 20%
3.0V/cell 3.2V/cell
L4
L3
(Aggressive)
100%
11
6 7
25% 30% 40%
3.4V/cell
8