Getting Started - Alpine X800D-U Guide De Référence Rapide

Getting Started

Touch operation
You can operate the system by using the touch panel on the screen.
e
Common onscreen buttons
: Returns to the previous screen. Depending on the function, this button may cancel the operations
performed on the screen.
: Closes the window.
Location of Controls
A
RESET switch
The system of this unit is reset.
B
(My Favourites) /
The My Favourites screen for registered User1 or User2
is displayed.
Press and hold this button at least 3 seconds to switch
to climate screen. You can check the air condition, etc.,
when this unit is connected to the car's CAN Interface
box.
C
/ (DOWN/UP) button
Press to adjust the volume.
D
MUTE/C button
Press to activate/deactivate the mute mode. Press and
hold this button for at least 3 seconds to turn the
power off.
E
/AUDIO button
Displays the Audio/Visual screen. If the Audio/Visual
screen is already displayed, changes the source. Press
and hold this button for at least 3 seconds to activate
the "Easy Sound Setup" mode.
Turning Power On or Off
1
Turn the ignition key to the ACC or ON position.
The system is turned on.
2
Press and hold the MUTE/C button for at least 3 seconds to turn the power off.
Owner's manual
• The illustration is for X800D-U.
button
Touch operation, Location of Controls, Turning Power On or Off
F
(MAP) button
Recalls the navigation map screen.
Press again to switch to Navigation menu screen.
Press and hold this button for at least 3 seconds to
change to Go Home route screen. If the Home is not
set yet, it will change to Home setting screen.
G
(PHONE) button
Recalls the Telephone Menu screen.
When a hands-free phone with Voice Recognition is
connected, press and hold for at least 3 seconds to recall
the Voice Recognition mode.
a / d button
H
Press to seek down/up station in radio mode or down/
up track, chapter, etc., in other audio/visual source.
c (Eject) button
I
Recalls the Open/Tilt screen.
If the disc does not eject after touching [c] of DISC,
press and hold this button for at least 5 seconds.
J
Remote Sensor
Point the remote control transmitter towards the
remote sensor within a range of 2 metres.
3
-EN