DeWalt DCF6201 Guide D'utilisation page 6

Proper Hand Position (Fig. 3)
WARNING: To reduce the risk of serious personal injury, ALWAYS
use proper hand positions as shown in Figure 3.
Proper hand position requires one hand on the rear grip. Take care to
not block the air vents on the screwgun.
FIG. 3
CAUTION: NEVER grip the collated attachment, use it as a handle
or touch the screw strips while in operation as shown in Figure 4.
FIG. 4
Page dimensions: 8.5 x 5.5
Setting Magazine Screw Length (Fig. 5)
This magazine is designed for 1"– 2" (20– 50 mm) screw lengths.
Failure to set the correct screw length can cause screws to not be
driven accurately which can result in the failure to advance to the next
screw or screws not being driven properly. The shoe has marked
specific slots for each of the most common screws, however this
attachment can still drive any size screw between 1"– 2" (20– 50 mm).
To accommodate for less common screws adjust to the next longest
slot.
CAUTION: Do not adjust while a
screw strip is in the magazine.
1. Slide screw length adjustment
tab (B) to the left.
2. Holding the screw length
adjustment tab in place, adjust
the shoe (E) to the desired
length.
3. Release the screw length
adjustment tab. Make sure
that the locking pin has fully
returned and is in the correct
position.
4
FIG. 5
B
E