When To Replace The Exhaust Filter; How To Replace The Airclean Filter; How To Replace An Airclean Plus 50, Silence Airclean 50, Active Airclean 50 And Hepa Airclean 50 Filter - Miele Complete C3 SG 3 Serie Mode D'emploi

en
 Close the filter frame.
 Fit the dustbag into the blue holder
as far as it will go.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.

When to replace the exhaust filter

Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
12).
a AirClean
Replace this filter every time you start a
new packet of dustbags. Every packet
of original Miele dustbags contains one
AirClean exhaust filter. Multipacks con-
tain four AirClean filters.
b AirClean Plus 50 (light blue)
Replace this filter after approx. one
year. Make a note of the date on the fil-
ter.
c Silence AirClean 50 (grey)
d Active AirClean 50 (black)
e HEPA AirClean 50 (white)
Replace this filter when the exhaust fil-
ter TimeStrip change indicator is com-
pletely red (dia. 17). The indicator lights
up after approximately 50 hours of op-
eration, which is equivalent to about a
year of average use. You can continue
vacuuming when the light comes on.
However, the suction power will be re-
duced as will the effectiveness of the fil-
ter if it is not replaced in good time.
56

How to replace the AirClean filter

(dia. 41 + 42)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Press the release catch on the filter
grille and open the grille as far as it
will go.
 Grasp the used AirClean filter by one
of the clean, unsoiled sections and
take it out.
 Replace it with a new AirClean ex-
haust filter.
If you wish to fit an AirClean Plus 50,
Silence AirClean 50, Active AirClean
50 or HEPA AirClean 50, see "Main-
tenance - Replacing one type of ex-
haust filter with another".
 Close the filter grille.
 Close the dust compartment lid.
How to replace an AirClean Plus 50,
Silence AirClean 50, Active AirClean
50 and HEPA AirClean 50 filter?
(dia. 43 + 44)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter, making it
sure it goes in properly, then push it
down into position.
 If you are using exhaust filter c, d or
e, press the exhaust filter TimeStrip
change indicator (dia. 15).