Storage And Maintenance - GYS MATIC AIR TH2 Instructions

Read and understand the following safety recommendations before using or servicing the unit.
Any change or servicing that is not specified in the instruction manual must not be undertaken.
The manufacturer is not liable for any injury or damage due to a non-compliance with the instructions featured this manual.
In the event of problems or uncertainties, please consult a qualified person to handle the installation properly.
Read the GYSMATIC 9/13 XL (ref. 065727) or 5/13 XXL (ref. 047846) instruction manual before using the corresponding air purifying/respiratory unit.
INTRODUCTION
The particle filter TH2/TH3 is intended for the breathing system of the welding helmet GYSMATIC 9/13 XL (ref. 065727) or 5/13 XXL (ref. 047846),
designed to provide a supply of filtered air via a breathing tube.
The equipment can be used in environment that requires a class TH2P (TH2 filter) oder TH3P (TH3 filter) breathing protection device.
It protects against particulate contamination.
The operation temperature range of the filter is -5°C to +55°C.
It should be used together with the pre-filter and spark arrestor.
3
The filter must not be installed directly in the helmet, or modified. An effective filtration cannot be ensured if one or some of the filter's parts are
modified.
The filter must be replaced at the same time as the pre-filter.
ASSEMBLY
1
Place the spark arrestor into the filter cover.
(Clean or change the spark arrestor if necessary)
3

STORAGE AND MAINTENANCE

The filter should be stored in a clean, dry place within the temperature range of -10 ° C to + 60 ° C and relative humidity below 90% RH.
The filter expected lifetime is 12 months. When under intensive use, check the filter cleanliness periodically and if needed, change it more often than
every 12 months.
The filter should not be used when the storage expiration date marked on it is exceeded.
PARTICULATE FILTER FOR GYSMATIC AIR
1
2
Place the filter.
1- TH2 filter (ref. 038424) / TH3 filter (ref. 065734)
2- Pre-filter (ref. 038417)
3- Spark arrestor
2
Place the pre-filter.
4
EN
Lock the tab.
3