Marmitek Connect 421 UHD Guide Utilisateur page 5

4. INSTALLATION
Installation tips:
x
Turn off all devices (TV and HDMI sources) before connecting them to the
Connect 421 UHD™. If a device cannot be turned off, please remove the plug
from the socket.
x
Only use High Speed HDMI® certified cables for the best picture and sound
quality. Using too much force to connect or disconnect the HDMI cables may
damage them.
1. Use an HDMI cable to connect the HDMI sources (such as game consoles, Blu-
ray players and Digital TV Decoders) to the HDMI ports marked "HDMI input".
2. Use an HDMI cable to connect the TV to the HDMI port marked "HDMI output". To
use the ARC function, your TV should support it. Please refer to your TV's manual
to check which HDMI port supports ARC.
3. Connect the AV amplifier to the output marked either "Digital" or "Stereo".
x
Use an optical cable for "Digital"; this output supports the audio formats DTS,
Dolby Digital and PCM 2.0.
x
Use a stereo cable for "Stereo"; this output supports the analogue stereo
audio format.
4. Connect the power adapter to the "DC 5V" and insert the plug into the socket.
5. Pull the plastic strip from the remote control's battery compartment to activate the
battery and remove the protective film from the top.
5. USE
Switching between connected HDMI devices
The Connect 421 UHD™ allows you to choose which HDMI source is displayed on the
TV. If you turn on one of the HDMI sources, it will automatically switch to the correct
input. If multiple HDMI sources are turned on, the Connect 421 UHD™ will
automatically switch to the HDMI source that was activated last. If you want to select
another HDMI source, please use the remote control or the "Select" button on the front.
Note: Automatic switching must be supported by the HDMI source. If it is not
supported, you should manually select the appropriate HDMI source.
CONNECT 421 UHD™ 5