Start-Up; Removing Iso-Strips; Inserting/Changing Batteries; Operation - ADE Bridget Mode D'emploi

Start-up

Removing iso-strips

When the scales are delivered, the battery is already inserted and fitted with iso-strips
to prevent it from discharging ahead of time. In order to start up the scales, you must
remove the iso-strips. The battery compartment is located on the underside of the
device.
1. Slide off the battery compartment cover in the direction of the arrow.
2. Pull out the iso-strips.
3. Slide the battery compartment cover back into place.

Inserting/changing batteries

For use you require 1 batteries of type CR2032, 3 V.
1. Slide off the battery compartment cover in the direction of the arrow.
2. Push the batteries against the contact springs under the large, angular retaining
tabs. The batteries then snap into the opposite retaining collars, such that the
batteries sit firmly in their retainers.
Pay attention to the correct polarity (+/-). The plus pole (+) must point upwards.
3. Put the battery compartment cover back in place. The locking tab must snap
securely into place.
Notes on changing the battery:
‚ A change of batteries becomes necessary when "LO" appears on the
display, or when nothing at all is displayed.
‚ Only use the type of battery that is specified in the "Technical Data".
‚ Dispose of batteries in an environmentally appropriate way (see
"Disposal").

Operation

Weighing

1. Place the scales on an even, firm, and dry surface. Carefully position the scales in
order to avoid hard impacts to the sensors/feet and therefore to avoid damage.
2. Switch on the scales by pressing the
3. Choose the desired unit of measurement by repeatedly touching UNIT. Your options
are "g" (gram), "lboz" (pound), "fl.oz" (fluid ounce) and "ml" (millilitre). Note the
indicator in the display.
Office Scales KE 1700
button.
Start-up
17