Led Light Show; Technical Specifications; Energy Saving - LENCO SCD-650 Mode D'emploi

8. AUX IN
This allows you to connect an external player's sound through your unit.
1. Plug a 3.5mm audio cable (not included) into your external player's line out and the other end into
the AUX IN jack at the rear of the unit.
2. The unit will automatically enter AUX mode.
3. Start your external player to play music. The unit will output the sound.
4. To return to another mode, disconnect the audio cable from the unit.

9. LED LIGHT SHOW

The LED LIGHT SHOW at the speaker of the unit is created automatically based on the music source
being played.
1. To turn on the LED LIGHT SHOW slide the LIGHT switch to the ON position.
2. To turn off the LED LIGHT SHOW slide the LIGHT switch to the OFF position.
Note:
- If the brightness is too high, turn on the room lights or turn off the LED LIGHT SHOW.

10. TECHNICAL SPECIFICATIONS

FM Frequency Range
Maximum Number of MP3 Folder/File Support
AC Power Input
Batteries Operation
Speaker Output Power
Aux In
Headphone Out
Mic In
Dimension
Weight
Note:
Due to continuing improvements, technical specifications are subject to change without notice.

11. ENERGY SAVING

Due to ErP stage two requirement and protect the environment, the unit will switch to the standby mode
automatically once no music has been playing over 15 minutes.
To reactivate the unit, slide the FUNCTION switch to OFF and then slide to another.
87.5 - 108MHz
Limitation of 99 folders with a maximum of 999 files
AC 230V~50Hz 18W
6 x UM2 (C Size)
2 x 1.8W
3.5mm stereo jack
3.5mm stereo jack
3.5mm jack
241 (L) x 215 (D) x 120 (H) mm
1.1kg
11