Numatic SPL 17 HF Mode D'emploi page 11

The SPL / SPT trolley comes with its own stand-alone charger.
Insert the charging lead required for your country into the charger.
Connect the charger to a suitable power supply.
Once mains power is connected the red charging indicator will illuminate.
To ensure a full charge, the battery should be left for a period of 6 hrs.
Once fully charged, disconnect the charging lead from both the power
Recharge the machine fully after its last use.
Do not leave the machine in a discharged state.
If the machine will be standing unused for a period of 30 days or more, then
batteries must be fully charged.
Spare replacement batteries are available from your supplier.
See SPL / SPT Spares list for part numbers.
Under abnormal use;
i.e. leaving the machine without charging for a period of time, we advise
that you disconnect the battery from the machine.
Note:
Charge fully the day before you start using the machine again.
The battery pack comes with a 40 amp safety fuse fitted
Replace the fuse using (208526) Numatic approved part.
supply and the machine.
Batteries should be recharged every three months.
Removing the battery pack fuse
11