Installation - Summit SP5DS2DBLK Guide D'utilisation

English

Installation

1. Take off hinge cover(Part #1, page 3) with upwards motion. Refer to illustration
below:
2. Take the anti-tip bracket and screws from the accessory bag. Tighten the anti-tip
bracket on the top of the product with screws as follows in the illustration.
Note: Follow instructions properly or you may do damage to product.
ANTI-TIP BRACKET
3. Pull upper drawer open and attach the anti-tip bracket to counter by screw upper drawer open and attach the anti-tip bracket to counter by screw
as seen below. Adjustment of the leveling legs under the unit may be
necessary for a proper fit in the cabinet opening. Start with the rear legs(if
necessary) before you slide the unit fully into the opening-rise or lower the
rear legs to make the unit fit properly. Then carefully slide the unit into opening
as not to damage accidently cabinetry or the floor. Then perform the same
adjustments to the front leveling legs to bring the front of unit to the proper
level to install the anti-tip bracket and fit evenly under the counter.
4. Another set of anti-tip brackets for side installation is provided as option
when the counter top is granite and hard to fix by screws. This set of brackets
include two anti-tip brackets and eight screws for installation on left side and
right side of the cabinet. Below illustration shows this, the drawer needs to be
open to perform this procedure.
5
SCREW
SCREW
ANTI-TIP BRACKET
Kitchen
Cabinet
Screwdriver
30~50
Right side
SCREW
ANTI-TIP BRACKET
Kitchen
Cabinet
Screwdriver
Left side