Machine Assembly; Mounting On 1206 Stand; Mounting 311A Carriage And Tools - RIDGID 300 Power Drive Manuel D'utilisation

• 418 Oiler
• 1 Gallon Nu-Clear Thread Cutting Oil
• 32 Transporter
Catalog Model
No. No. Description
41855 300 Only 115V,25-60 Hz
75075 300 Only 115V,25-60 Hz
41860 300 Only 230V,25-60 Hz
75435 300 Only 230V,25-60 Hz
15682 300 115V,25-60 Hz
Complete 1/2" – 2" NPT
15722 300 115V,25-60 Hz
Complete 1/2" – 2" NPT

Machine Assembly

WARNING
To prevent serious injury, proper assembly of the
Power Drive is required. Failure to mount the
Power Drive to a stable stand or bench may result
in tipping and serious injury. The following proce-
dures should be followed:
Mounting on No. 1206 Stand
1. Set up the 1206 Stand by opening legs and pushing
down on the tray. Legs should be stiff and the stand
should not wobble.
NOTE! The tristand leg stiffness can be increased or
decreased by the following procedure:
• Place stand upside down on a flat surface.
• Unlock tray so legs are loose.
• Locate the set screw on the tray leg support on the
rear leg (Figure 3).
• Loosen the set screw to make the adjustment. To
increase stiffness, move the tray leg support up
towards the base. To decrease stiffness, move
the tray leg down towards the feet.
• Tighten the set screw (increasing leg stiffness
increases tray tension).
Spindle Weight
Speed
RPM Lb. Kg.
38 94 43.0
57 94 43.0
38 94 43.0
38 94 43.0
38 212 96.2
57 212 96.2
300 Power Drive
2. Mount power drive on the stand using bolts and wing
nuts (Figure 3).
REV/OFF/FOR
Switch
Centering
Device
Pipe
Bolt (4)
Wing Nut (4)
Rear Leg
Set Screw
Foot Switch
Figure 3 – 300 Power Drive Mounted on No. 1206 Stand
with 418 Oiler

Mounting 311A Carriage and Tools

1. Inspect the support bars to insure they are forward
and secured by two (2) retaining ring assemblies.
Retaining ring set screws must be tight (Figure 4).
Chuck Jaw
Handwheel
Set Screw (2)
Retaining
Ring Assy. (2)
No. 1206
Stand
5