Connecting The Device To The Power; Connecting The Device To A Computer Or Computer Network; Switching The Device On And Off - HellermannTyton TT4000+ Manuel D'utilisation

Initial operation
Keep the original packaging for later transport.
If transport damage has been found or if the scope of
delivery was incomplete, please contact Customer Service at
HellermannTyton.
; The device has been setup correctly.
5 .2 Connecting the device to the power supply
DANGER
Danger of lethal electric shock!
There is a risk of lethal injury when touching live
components.
f Only connect the device to a properly installed and
standardised socket with grounding.
f Observe the voltage and amperage requirements.
f Do not touch any of the live components.
Network and computer connections.
22 Power switch
23 Power connection jack
24 Slot for PC Card Type II
25 Slot for CompactFlash memory card
26 Ethernet 10/100 Base-T
27 2 USB master interfaces for key pad, scanner or service key
28 USB high-speed slave interface
29 Serial RS232 C port
The printer is equipped with a wide area power unit. The
device can be operated with a supply voltage of
230 V~/50 Hz or 115 V~/60 Hz without adjustment.
Proceed as follows:
1 Check that the power switch is in the "0" position.
2 Plug the power cable into the power connection socket.
3 Plug the power cable into a grounded socket.
; The device is connected to the power supply.
10
22
23
24
25
26
27
28
29
Operating Instructions • Thermal transfer printer TT4000
5 .3 Connecting the device to a computer or
computer network
NOTE
Material damage caused by improper work!
Inadequate or no grounding of the components can cause
malfunctions during operations.
f Only connect the device to a properly installed and
standardised socket with grounding.
Proceed as follows:
1 Connect the device according to the "Configuration
instructions".
; The device is connected to a computer or computer
network.

5 .4 Switching the device on and off

Proceed as follows:
1 Check that all connections have been made.
2 Switch the device on using the power switch.
3 The device automatically performs a system test.
4 The device shows the system status READY on the
display or
5 Rectify error, see 8, page 23.
; The device is connected to a computer or computer
network.
+ • 01-2016 • 031-93352