Dantherm CDP 40 Manuel D'entretien page 4

EN
Water heating coil for CDP dehumidifier - mounting
Installation procedure
1. Remove front cover
3. Pre-assemble gaskets, fittings and flexible hoses.
5. Connect hoses to external heating source.
Note: the hoses run through the wall behind the unit.
7. Cut along dotted lines and fit grommet around flex hose.
Push grommet and hose in place using liquid detergent for
lubricant.
4
2. Punch out the two discs in the rear of the unit.
4. Slide heating coil into place.
6. Secure heating coil with two screws left and right front.
8. For CDP-T models the hoses are at the end of the unit.