Pioneer PDK-TS06 Mode D'emploi page 18

Mounting the plasma display on the stand
1
. Insert the plasma display into the stand.
Check that the stand and plasma display are facing the proper direction, then insert the plasma
display into the stand.
This procedure should be done by at least three persons, since the plasma display is heavy and
has a high center of gravity. Hold the bottom and the grips on the back of the plasma display and
support the top when inserting the plasma display into the stand.
Hold both sides of the plasma display and lift it up, then
place the plasma display onto the stand so that the holes
located at the bottom of the display engage with the stand.
2
. Fasten the plasma display and stand.
Pull the top of the plasma display forward and while doing so, insert
the four supplied display mounting screws into the holes in the stand
and tighten them.
CAUTION:
Tighten the screws immediately after placing the display on the stand.
If not, the display could tip over, resulting in injury.
E-8