Ryobi LLCD1402 Manuel D'utilisation page 6

GB
FR DE ES IT
SPECIFICATIONS
MODEL BATTERY PACK
(not included)
BPP-1413
BPP-1415
BPP-1417
LLCD1402
BPL1414
OPERATION
WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
Drilling in all types of wood products (lumber, plywood,
■
paneling, composition board, and hard board)
Drilling in ceramics, plastics, fiberglass, and laminates
■
Drilling in metals
■
Mixing paint
■
This product will accept Ryobi 14.4 V lithium-ion battery
packs and Ryobi 14.4 V nickel-cadmium battery packs.
NL PT DK SE FI NO
English
CHARGER
(not included)
BCL1418
BCL14181H
BCL14183H
BC-1440
BCA-144
BC-1415-S
BCL1418
BCL14181H
BCL14183H
RU PL CZ HU RO LV
BATTERY PROTECTION FEATURES
Ryobi 14.4 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these
built-in features may cause the battery and the tool it is
powering to act differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to
stop running. To reset the battery and tool, release the
trigger and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and
tool, the battery pack is depleted. If depleted, the battery
pack will begin charging when placed on the lithium-ion
charger.
TO INSTALL BATTERY PACK
See Figure 2.
Place the rotation selector in the center position.
■
Insert the battery pack into the product as shown.
■
Make sure the latches on each side of the battery
■
pack snap in place and that battery pack is secured in
the product before beginning operation.
TO REMOVE BATTERY PACK
Depress the latches on each side of the battery pack.
■
Remove the battery pack from the drill.
■
SWITCH TRIGGER
See Figure 3.
To turn the drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
VARIABLE SPEED
The variable speed switch trigger delivers higher speed
with increased trigger pressure and lower speed with
decreased trigger pressure.
NOTE: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned; this is a
normal part of the switch function.
2
LT EE HR SI SK GR TR