Drill Safety Warnings - Ryobi LLCD1402 Manuel D'utilisation

GB
FR DE ES IT

DRILL SAFETY WARNINGS

Hold power tool by insulated gripping surfaces
■
when performing an operation where the cutting
tool may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
Use auxiliary handle(s), if supplied with the tool.
■
Loss of control can cause personal injury.
Always wear safety glasses with side shields.
■
Everyday glasses have only impact resistant lenses.
They are NOT safety glasses. Following this rule will
reduce the risk of eye injury.
Protect your lungs. Wear a face or dust mask if the
■
operation is dusty. Following this rule will reduce the
risk of serious personal injury.
Protect your hearing. Wear hearing protection
■
during extended periods of operation. Following
this rule will reduce the risk of serious personal injury.
Battery tools do not have to be plugged into an
■
electrical outlet; therefore, they are always in
operating condition. Be aware of possible hazards
when not using your battery tool or when changing
accessories. Following this rule will reduce the risk of
electric shock, fire, or serious personal injury.
Do not place battery tools or their batteries near
■
fire or heat. This will reduce the risk of explosion and
possibly injury.
Do not crush, drop or damage battery pack. Do
■
not use a battery pack or charger that has been
dropped or received a sharp blow. A damaged
battery is subject to explosion. Properly dispose of a
dropped or damaged battery immediately.
Do not charge battery tool in a damp or wet
■
location. Following this rule will reduce the risk of
electric shock.
For best results, your battery tool should be
■
charged in a location where the temperature is
more than 10°C but less than 37.78°C. To reduce
the risk of serious personal injury, do not store outside
or in vehicles.
NL PT DK SE FI NO
English
RU PL CZ HU RO LV
DESCRIPTION
1. Keyless Chuck
2. Switch Trigger
3. Rotation Selector (Forward/reverse)
4. Battery Pack (not included)
5. Latches
6. Depress Latches To Release Battery Pack
7. Torque Adjusting Ring
8. To Decrease Torque
9. To Increase Torque
10. Reverse
11. Forward
12. Unlock (Release)
13. Lock (Tighten)
14. Chuck Jaws
15. High Speed
16. Low Speed
17. Two-Speed Gear Switch
18. Bit Storage
19. Double-Ended Bit
20. Drill Bit
SPECIFICATIONS
Voltage
Chuck
Switch
No load speed (drill mode):
- Lo speed
- Hi speed
Clutch
Max. Torque
Max. Spade Bit
Weight - not incl.battery pack
1
LT EE HR SI SK GR
14.4 V
0.8-10 mm
Variable speed
0 - 400 min -
1
0 - 1400 min -
1
24 Positions
25 Nm
20 mm
1.08 Kg
TR