VOLTCRAFT CHARGE MANAGER 2016 Notice D'emploi page 45

Briefly pushing „OK" suffices to confirm at once.
If no input is made, the programme „CHARGE" starts automatically with the automatic
charging current setting after approx. 6 seconds.
The desired programme is selected with the selection buttons. Five different programmes
are available.
„SET CHARGE"
„SET DISCHARGE" = Discharge (no maintenance charge!)
„SET CHECK"
„SET CYCLE"
„SET ALIVE"
Description:
• „CHA" („CHARGE") means that the inserted battery is being charged.
• „DIS" („DISCHARGE") means that the inserted battery will only be discharged. There is
no maintenance charge.
• „CHK" („CHECK") means that a charge follows the discharge.
• „CYC" („CYCLE") means that the inserted battery will be first charged, then discharged
and finally recharged.
• „ALV" („ALIVE") means that the battery must go through several charge and discharge
cycles. The „ALIVE" programme is used for activating new batteries and batteries that
were stored for an extended period of time.
Depending on the selected programme and battery type, the charge or discharge current
may also be selectable. Otherwise, the programme starts automatically with the pre-
settings.
= Charging
= Discharge -> charge
= Charge -> discharge -> charge
= Charge -> discharge -> charge -> discharge -> charge
45