Installation Instructions; Important - Koala Kare KB200-SS Instructions D'installation Et D'utilisation

INSTALLATION INSTRUCTIONS

Step 2. Prepare Mounting Surface
For Standard Installation
Remove the bed and chassis from the
box and select the wall area where the
unit will be installed. Make sure you have
taken into consideration the operating
clearance of 9½" (241 mm) on both
sides of the exposed chassis and 23
(589 mm) from wall surface when open.
Measure from the floor 42¼" (1073 mm)
on stud center and mark the wall. The
mounting holes are designed for 16" stud
centers. Ensure the locations you have
marked for the mounting holes are level
before drilling. Drill pilot holes for keyhole
mounting using a 1/8" regular drill bit.
For Masonry or Tile over Stud Wall
Use a 7/32" (5 mm) masonry drill bit for the
pilot hole until you hit the stud. Change bit
to 1/8" (3 mm) regular drill bit.
For Metal Stud or Concrete Block
If the wall has wood studs that are not on
16" (406 mm) centers, has metal studs or
an underlying surface of concrete block,
drill with a ½" masonry bit. (You may have
to purchase toggles before installing.) You
must allow a minimum of 2½" (64 mm)
of inside wall space for toggles to turn.
Insert and tighten toggles. Position unit
over toggles and insert ¼" x 3" Phillips
panhead machine screws with washers.
3
23 3 / "
16
(589 mm)
/ "
3
16

Important:

In Step 3, all
SIX screws
provided must
be mounted to
the chassis to
ensure proper
load bearing
capacity!
9½"
(241 mm)
(40,6 cm)
Top two screws at
42¼" (107 cm) to
meet ADA Height
Requirements
9½"
(241 mm)