Cleaning And Maintenance - WMF KULT X Mode D'emploi

Start-up
Soft fruit and cooked vegetables can be strained and baby food or purée can be
prepared with the purée rod (6). Coarsely chop large pieces in advance.
Please clean all parts described in the "Cleaning and maintenance" section before
allowing them to come into contact with food.
Prepare the desired food and fill a sufficiently high and stable receptacle with the
food.
Make sure that the device is disconnected from the power supply.
Attach the purée rod (6) at the bottom to the coupling of the drive unit (4) at the
symbol (5) and turn this clockwise to the symbol (5) until these are one above
the other. Click the purée rod (6) into place. The purée rod (6) must sit firmly on
the device and should not be loose or fall off.
Using the swivel (1) on the top of the device, select the desired speed. You can
also change this during operation.
Keep the purée rod (6) in the food.
Caution: Spray occurs easily during operation. To avoid spray, the lower end of
the purée rod (6) with the blades should always be completely covered. Keep the
device slightly angled with liquid foods in order to achieve a better mixing.
If you are preparing hot food, then be sure not to hold the device in the rising
steam so as to avoid condensation on the drive unit (4).
You may wish to protect the drive unit (4) and your hands from hot steam with a
small clean kitchen towel. Immediately wipe off the condensation on the housing.
First insert the power plug into the socket.
Hold the container with one hand and press the On button (3). The motor
starts to operate and the indicator light (2) illuminates.
As soon as your food has the desired properties, release the On button (3).
Wait for the motor and purée rod (6) to come to a standstill and then remove it
from the container.
Always remove the power plug from the socket before you place the device on a
suitable base.

Cleaning and maintenance

Remove the power plug immediately after use.
Clean the purée rod (6) immediately after each use so that dried food residue
does not damage the purée rod (6) during storage.
For pre-cleaning, simply briefly run the purée rod (6) in a container filled with hot
water.
To be cleaned, the purée rod (6) must be removed by turning it in a counter-
clockwise direction.
The drive unit (4) must not be cleaned in a dishwasher.
The drive unit (4) should never be placed in water, only wiped down on the
outside with a damp cloth. Do not use any abrasive cleaning agents.
12