sylvac PS16 V2 Mode D'emploi page 5

2.2 Optional stops
The PS16 V2 is equipped with 2 optional stops (at the front and back of the
instrument). Used in combination, they allow the travel to be restricted in 2
directions (opening/closing) so that the position and the measuring travel can
be adjusted to suit the workpiece.
This prevents the anvils from coming back into contact (0) and having to repeat the
E
full travel with each measurement. The stop is engaged by pushing the radial button
(8).
The stop positions are adjusted by positioning the release lever (see chap. 2.1). If 2
stops are being used, the release lever has a set position that cannot be modified.
2.3. Measuring force
The measuring force can be adjusted by moving the adjustment knob (10) as follows:
unscrew the knob (~1/2 a turn), position it at the required force and re tighten it.
Optimise the measuring force setting for workpiece weight and deformation. Do not
adjust the measuring force during a measurement process.
Force for external measurement PS16 V2 25mm
5