sylvac PS16 V2 Mode D'emploi page 24

12. Accessories
12.1. XZ Table
E
2
1
12.1.1. Description
1. Fine height adjustment screw
2. Plate locking screw
3. Horizontal locking lever
4. Height locking screw
5. Closure plug
6. Comparator probe
7. Plug / comparator retaining screw
8. Vertical movement indication comparator (sold separately)
12.1.2. Use :
• After positioning it horizontally in the desired location it lock the table using
the locking lever (3)
• Unlock the plate using the locking screw (2) and move it manually close to
the desired height.
• Adjust the desired height accurately using the fine adjustment screw (1).
Lock as needed using the locking screw (4)
12.1.3. Fitting the comparator: (option) :
• Unlock the locking screw (7) and remove the closure plug (5) with the assistance
of an M2.5 screw if necessary.
• Remove the special conical contact point (6) behind the plug and screw on the
comparator measurement plunger.
• Raise the table as far as it will go using the fine adjustment screw (1) before
inserting the comparator until it stops.
• Moderately tighten the locking screws (7)
3
4 5 6 7
24
8